Add To Cart
share
Sick WLG4-3F3182S06 Description
- Scanning range 0.01 - 4 m
- Fast and reliable alignment due to extra bright light spot
- Detection of glass with damping > 8% (version with polarization filter)
- Detection of PET bottles and films with damping > 8% (version without polarization filter)
- Sensitivity control also via cable
- The PinPoint LED's sharply defined, intensive light spot makes alignment of the WLG4-3 fast and simple
- Unproblematic and wide usage as virtually all known transparent objects can be reliably detected
- Simple and fast setting with a single press of the teach-in button
Your benefits
| Features | |
| Dimensions (W x H x D):: | 16 mm x 39.5 mm x 12 mm |
| Sensing range max.: | 0.01 m ... 1.5 m 1) |
| Sensing range: | 0.02 m ... 0.4 m 2) |
| Housing desig (light emission): | Flat |
| Light source: | PinPoint LED 3) |
| Type of light: | visible red light |
| Wave length: | 650 nm |
| Adjustment: | adjustable |
| Sensitivity adjustment: | Adjustable Teach 4) 5) |
| Teach-in: | single |
| Sensor/detection principle: | Photoelectric retro-reflective sensor, autocollimation |
| Light spot (distance): | 25 mm (200 mm) |
| 1) 2) PL80A 3) Average service life 100,000 h at Ta = +25 C 4) 5) | |
| Mechanics/electronics | |
| Enclosure rating: | IP 67 |
| Supply voltage: | 10 V DC ... 30 V DC 1) |
| Residual ripple: | < 5 Vpp 2) |
| Power consumption: | ≤ 30 mA 3) |
| Switching output: | PNP, light switching |
| Output current Imax.: | ≤ 100 mA |
| Response time: | < 0.5 ms 4) |
| Switching frequency: | 1,000 Hz With light/dark ratio 1:1 |
| Connection type: | Cable with plug, M8, 3-pin 100 mm 5) |
| Cable material: | PVC |
| Conductor cross-section: | 0.14 mm2 |
| Cable diameter: | 3.4 mm |
| Protection class: | III |
| Circuit protection: | A C D 6) 7) 8) |
| Weight: | 30 g |
| Housing material: | ABS |
| Optics material: | PMMA |
| Ambient temperature, operation: | -40 C ... 60 C |
| Ambient temperature, storage: | -40 C ... 75 C |
| Angle of reception: | 30 |
| Attenuation along light beam: | > 8 % |
| Special Design: | for transparent objects |
| Special features: | without polarisation filter |
| 1) Limit values 2) May not exceed or fall short of VS tolerances 3) Without load 4) Signal transit time with resistive load 5) Do not bend below 0 C 6) A = VS connections reverse-polarity protected 7) C = interference suppression 8) D = outputs overcurrent and short-circuit protected | |
Contact Us
Hot Products