Add To Cart
share
SICK WSE4T-3P1430 Overview
WSE4T-3P1430 Photoelectric through beam switch range 3 m, PNP, light switching, in robust Teflon case, test input, 5 m cable, 3 wire, 2 m cable in teflon hose
SICK WSE4T-3P1430 Description
- Robust Teflon coating of sensor and cable
- Suitable for use in the food industry
- Through-beam photoelectric sensor with a scanning range of 0 - 3 m
- Simple alignment thanks to highly visible intensive light spot
- High cost savings since development or mounting of a protective housing is not needed. Entire sensor including cable is Teflon-coated so it can be placed directly in the process.
- Simple and fast alignment due to highly visible PinPoint light spot
- Less machine downtime due to long-life sensor, which even defies the most aggressive cleaning and process agents.
Your benefits
| Features | |
| Dimensions (W x H x D):: | 22 mm x 42 mm x 21.8 mm |
| Sensing range max.: | 0 m ... 3 m |
| Sensing range: | 0 m ... 2.5 m |
| Housing desig (light emission): | Flat |
| Light source: | PinPoint LED 1) |
| Type of light: | visible red light |
| Wave length: | 650 nm |
| Adjustment: | no/fix |
| Sensor/detection principle: | Through-beam photoelectric sensor |
| Light spot (distance): | 210 mm (2 m) |
| 1) Average service life 100,000 h at Ta = +25 C | |
| Mechanics/electronics | |
| Enclosure rating: | IP 68 IP 69K |
| Supply voltage: | 10 V DC ... 30 V DC 1) |
| Residual ripple: | < 5 Vpp 2) |
| Power consumption: | 20 20 20 3) 4) 5) |
| Switching output: | PNP, light switching |
| Output current Imax.: | 100 |
| Response time: | < 0.5 ms 6) |
| Switching frequency: | 1,000 with light/dark ratio 1:1 |
| Connection type: | Cable, 3-wire 5 m 7) |
| Cable material: | PVC/teflon coating |
| Conductor cross-section: | 0.14 mm2 |
| Cable diameter: | 3.4 mm |
| Protection class: | III |
| Circuit protection: | A C D 8) 9) 10) |
| Weight: | 30 g |
| Housing material: | PTFE/teflon |
| Optics material: | PMMA |
| Ambient temperature, operation: | -40 C ... 60 C |
| Ambient temperature, storage: | -40 C ... 75 C |
| Test input sender off: | TE to 0 V |
| 1) Limit values 2) May not exceed or fall short of VS tolerances 3) Sender 4) 5) Receiver 6) Signal transit time with resistive load 7) Do not bend below 0 C 8) A = VS connections reverse-polarity protected 9) C = interference suppression 10) D = outputs overcurrent and short-circuit protected | |
Contact Us
Hot Products